 |
|
|
I have been asked to include some screen captures of the ProEFI Software and the Data logging Software. |
|
|
This is a screen capture of the ProEFI Com. I opened a few different
windows so you could see some of the maps. These are the maps that I
use the most (Fuel and Ignition). The ignition map is pretty much set for
pump gas. It will get more agressive with race gas. There are two different
versions of the fuel map. One is the table view and the other is a graphical
view. I primarily use the graphical view to make sure the fuel map is smooth.
I also am showing the Parameters. This is a way to monitor the real time
operation of the vehicle.
This second screen capture is designed to show you the different tables and
maps available to you. You can look through the list. Most of these you will
not touch. You will leave the values that come preconfigured. That also will
hold true for the Options. Options are designed to allow you to adjust your
upper and lower limits of your tables and maps. My recommendation is not to
play with these, unless you know what you are doing. For example..These allow
you the ability to shut off your knock sensor correction.. I have the
parameters list again. I added a few more to this screen capture... There
are probably another 20-30 not listed. Any of these parameters can be data
logged by going to the Logging menu (not highlighted) and clicking Start.
This is a capture of the data logger. I included a 5th gear pull. You will notice
the parameters on the side. To read the logging, you slide a marker accross the
recording and your values will change over on the right...
|
